Few people know about wear-resistant coatings. It is a new type of functional coatings with good durability and durability. It is usually used on metal surfaces or lenses and glass, so that it has more wear resistance, so that it will not be scratched. So, today the editor will give you a specific introduction to the characteristics of wear-resistant coatings? What are the precautions for the use of wear-resistant coatings.

What are the characteristics of wear-resistant coatings

1. Binder is an important raw material for wear-resistant coatings, which can combine various components in the coatings together, and its firmness is very strong. It can make all kinds of products have a good protective film as long as they use wear-resistant coatings, which can firmly bond them together. The fluidity of the adhesive and the curability of the room temperature are relatively strong, which is very convenient for construction.

2. Lubricants can improve the wear resistance of wear-resistant coatings, and reduce the friction with the wall during painting, which is more convenient for construction. It can also make the effect of brushing more glamorous.

3. The ingredients of the reinforcing agent are mostly copper oxide powder, quartz powder, raw iron powder and some other metal powders, which can improve the surface hardness of the product and the mechanical strength of the coating to a certain extent, which can be well improved. The anti-wear properties of the coating.

Precautions for the use of wear-resistant coatings

1. Wear-resistant coatings are generally made by manual stirring and mechanical stirring. Normally, it is better to use mechanical stirring, usually the stirring time is 2-3 minutes. If manual stirring is used, you need to add two-thirds of the water for 4 minutes of stirring, and then add the remaining paint to stir until the effect is satisfactory. It is recommended to process as much as possible with a small amount of times when mixing, but it must be completed within 30 minutes.

2. The construction method of the wear-resistant coating should be carried out from top to bottom as far as possible, and press hard when plastering. And the thickness of each plastering is 20mm, and it is best not to exceed the thickness of 30mm. The construction time is also exquisite. It is best to control the completion of all procedures within 45 minutes, so the speed of each mixing and construction must be controlled.

3. When using wear-resistant coatings, construction should also be carried out according to climatic conditions. Generally, the coating will reach a preliminary solidified state within 1-2 hours, and then it will be calendered. Calendering treatment is the most important of all processes, so that the roughness of the anti-wear layer can be reduced after treatment, which is very conducive to smooth discharge.